Ap Extender
Читать 3 минуты
Ap.Setup
To access your AP setup or extender login, open a web browser and type 192.168.10.1 in the address bar. This will take you to the login page where you can enter your username and password to configure your settings. Make sure your device is connected to the network for a smooth setup process.
Ap.Setup using Wps Method
- Connect your AP or extender to a power outlet and wait for it to boot up.
- Find the WPS button on your router and the extender.
- Press the WPS button on your router. This usually activates the WPS mode.
- Within 2 minutes, press the WPS button on your extender.
- Wait for a few moments while the devices connect. The LED indicator on the extender will show the connection status.
- Once connected, the LED should indicate a successful connection (usually a solid green light).
- If needed, connect to the extender's network using your device.
- Enter 192.168.10.1 in the address bar to access the extender's setup page.
- Use the default username and password to log in.
- Follow any additional prompts to complete your setup and customize your settings.
Note: If you need any help regarding your wavelink wifi range extender so get in touch with the technician or visit the official web site that is 192.168.10.1
How do I setup the ap extender Manual Guide ?
- Connect your AP extender to a power outlet and wait for it to power on.
- Use a smartphone or computer to connect to the extender's default Wi-Fi network (usually listed on the device).
- Launch a web browser and enter 192.168.10.1 in the address bar to access the setup page.
- Enter the default username and password (often "admin" for both) to log in.
- Navigate to the network settings and choose your main Wi-Fi network from the list of available networks.
- Input the password for your main Wi-Fi network to connect the extender.
- Save the configuration settings and wait for the extender to apply the changes.
- Once the setup is complete, reconnect your devices to the new extended network, which may have the same name or a new suffix.
How do I login my AP extender?
- Connect to the extender's Wi-Fi on your device.
- Open a web browser (like Chrome or Firefox).
- Type the extender's IP address (often 192.168.0.1) in the address bar.
- Press Enter to access the login page.
- Enter the admin username (usually "admin").
- Enter the admin password (often "admin" or "password").
- Click the Login button.
- Navigate to the settings you need to change.
- Save changes and log out when done.
Firmware update for Ap extender setup
- Connect to the extender’s Wi-Fi on your device.
- Open a web browser and enter the extender's IP address.
- Log in with your admin credentials (username and password).
- Locate the Firmware Update section in the settings menu.
- Check for available updates by clicking the appropriate button.
- Download the latest firmware if an update is available.
- Select the downloaded firmware file if required.
- Click the Update button to start the update process.
- Wait for the update to complete, and do not turn off the extender.
- Reboot the extender if prompted, and log in again to confirm the update.
Ap.Setup Reset Process
- Locate the reset button on the AP extender.
- Press and hold the reset button for about 10 seconds.
- Release the button once the lights blink or change.
- Wait for the extender to reboot completely.
- Connect to the extender's default Wi-Fi network.
- Open a web browser and enter the default IP address.
- Follow the setup prompts to configure the extender again.
2 просмотра
Поделиться
Добавить
Еще